Dell S6100 Configuration Manual page 1524

To return to the default values, use the default logging buffered command.
To disable logging stored to an internal buffer, use the no logging buffered command.
Parameters
level
size
Defaults level = 7; size = 40960 bytes
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information When you decrease the buffer size, all messages stored in the buffer are lost. Increasing the buffer size does not
affect messages stored in the buffer.
Related Commands
•
•
•
1524 Simple Network Management Protocol (SNMP) and Syslog
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or debugging.
(OPTIONAL) Indicate the size, in bytes, of the logging buffer. The number of messages
buffered depends on the size of each message. The range is from 40960 to 524288. The
default is 40960 bytes.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
clear logging — clears the logging buffer.
default logging buffered — returns the logging buffered parameters to the default setting.
show logging — displays the logging setting and system messages in the internal buffer.