Logging Synchronous - Dell S6100 Configuration Manual

Version
7.5.1.0
E-Series legacy
command
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging
source-interface command, the Syslog packets contain the IP address of the interface configured.
Related Commands
•

logging synchronous

Synchronize unsolicited messages and Dell Networking OS output.
Syntax logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
Parameters
all
level level
all
limit number-of-
buffers
Defaults Disabled. If enabled without the level or number-of-buffers options specified, level = 2 and number-of-
buffers = 20 are the defaults.
Command Modes LINE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
Description
Introduced on the C-Series.
logging — enables logging to the Syslog server.
Enter the keyword all to ensure that all levels are printed asynchronously.
Enter the keyword level then a number as the severity level. A high number indicates a
low severity level and vice versa. The range is from 0 to 7. The default is 2.
Enter the keyword all to turn off all.
Enter the keyword limit then the number of buffers to be queued for the terminal after
which new messages are dropped. The range is from 20 to 300. The default is 20.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Simple Network Management Protocol (SNMP) and Syslog 1533