Dell S6100 Configuration Manual page 1683

Version
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.2)
9.2(0.0)
9.0.2.0
Example
Dell#show vlt mismatch
Domain
-------
Parameters
----------
Unit-ID
Vlan-config
------------
Vlan-ID
-------
00
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID
--------
Dell#
Example for Q-in-Q
Dell#show vlt mismatch
implementation over Domain
------
VLT
Parameters
----------
PB for stp
Vlan-type-config
----------------
Codes:: P - Primary, C - Community, I - Isolated, N - Normal vlan, M - Vlan-
stack
Vlan-ID
-------
100
Port-type-config
----------------
Codes:: p - PVLAN Promiscuous port, h - PVLAN Host port, t - PVLAN Trunk port,
port
Vlt Lag
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced support for Q-in-Q implementation over VLT on the S-Series and Z-Series.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Local
-----
1
Local Mode
----------
--
Local Status
------------
4094 Active
Local
-----
Enabled
Local
-----
N
mt - Vlan-stack trunk port, mu - Vlan-stack access port, n - Normal
Local
Peer
-----
2
Peer Mode
---------
L3
Peer Status
-----------
Inactive
Peer
----
Disabled
Peer
----
M
Peer
Virtual Link Trunking (VLT) 1683