Logging Trap - Dell S6100 Configuration Manual

Version
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information
When you enable logging synchronous, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on
that terminal line. Messages may continue to appear on other terminal lines.
Related Commands
•

logging trap

Specify which messages are logged to the Syslog server based the message severity.
Syntax logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level
Defaults 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
1534 Simple Network Management Protocol (SNMP) and Syslog
Description
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
logging on — enables logging.
Indicate a value from 0 to 7 or enter one of the following parameters: emergencies,
alerts, critical, errors, warnings, notifications, informational, or
debugging. The default is 6 or informational.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.