Dell S6100 Configuration Manual page 1614

Version
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information The following describes the show ntp associations command shown in the Example below.
Field
(none)
remote
ref clock
st
when
poll
reach
delay
offset
disp
Example
Dell# show ntp associations
remote
=============================================================
10.10.120.5 0.0.0.0
*172.16.1.33 127.127.1.0 11 6 16
172.31.1.33 0.0.0.0
192.200.0.2 0.0.0.0
1614 System Time and Date
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
One or more of the following symbols could be displayed:
• * means synchronized to this peer.
• # means almost synchronized to this peer.
• + means the peer was selected for possible synchronization.
• - means the peer is a candidate for selection.
• ~ means the peer is statically configured.
Displays the remote IP address of the NTP peer.
Displays the IP address of the remote peer's reference clock.
Displays the peer's stratum, that is, the number of hops away from the external time
source. A 16 in this column means the NTP peer cannot reach the time source.
Displays the last time the switch received an NTP packet.
Displays the polling interval (in seconds).
Displays the reachability to the peer (in octal bitstream).
Displays the time interval or delay for a packet to complete a round-trip to the NTP time
source (in milliseconds).
Displays the relative time of the NTP peer's clock to the switch clock (in milliseconds).
Displays the dispersion.
ref clock st when poll reach delay
16 - 256
16 - 256
16 - 256
offset disp
0 0.00 0.000 16000.0
377 -0.08 -1499.9 104.16
0 0.00 0.000 16000.0
0 0.00 0.000 16000.0