Vlan-Stack Access - Dell S6100 Configuration Manual

•

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
E-Series original
Command
Usage Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport command.
To remove the access port designation, remove the port (using the no member interface command) from all
stackable VLAN-enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible command.
show system (S-Series and Z-Series)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
– display the status of all stack members or a specific member.
VLAN Stacking 1643