Show Logging Driverlog Stack-Unit - Dell S6100 Configuration Manual

Oct 8 09:26:25: %RPM1:RP1 %BGP-5-ADJCHANGE: Connection with neighbor 1.1.14.2
closed. Neighbor recycled
--More--
Example (History)
Dell#show logging history
Syslog History Table: 1 maximum table entries,
saving level Warnings or higher
%RPM:0:0 %CHMGR-2-LINECARDDOWN - Line card 3 down - IPC timeout
Dell#

show logging driverlog stack-unit

Display the driver log for the specified hardware component.
Syntax show logging driverlog stack-unit stack-unit-number
Parameters
stack-unit stack-
unit-number
defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Example
Dell#show logging driverlog stack-unit 1
0:Task(tUsrRoot): [
ssnDrvPoePsuEepromWriteEnable : 66 - Psu 1 is Not Present Cannot enable
1:Task(tUsrRoot): [
1538 Simple Network Management Protocol (SNMP) and Syslog
SNMP notifications not Enabled
Enter the keywords stack-unit followed by the stack member ID of the switch for
which you want to display the driver log.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
491677]PSU FanCtrl Drv ERR:
338]PSU FanCtrl Drv ERR: ssnDrvPsuFanCtrlInit : 118 -