Konica Minolta bizhub C360 Service Manual page 1097

3. OTHER MAINTENANCE ITEM
[3]
[5] [4]
[1]
[1]
20
[2]
[1]
A10DF2C026DA
[2]
A10DF2C027DA
A10DF2C500DA
Field Service Ver. 2.0 Jan. 2010
4. Remove the harness from the cord
clamp [1].
5. Remove the C-clip [2], and remove
the drive lever [3].
6. Remove the tape [4], and disconnect
the connector [5].
7. Remove two screws [1], and remove
the leading edge grip solenoid [2].
8. Reinstall the above parts following
the removal steps in reverse.
NOTE
• Secure the plate edge section of the
leading edge grip solenoid by fit-
ting the mark-off line [1].