Mechanical Adjustment; Mechanical Adjustment Of The Punch Section; Punch Hole Deviation Correction - Konica Minolta bizhub C360 Service Manual

5. MECHANICAL ADJUSTMENT

5. MECHANICAL ADJUSTMENT
5.1

Mechanical adjustment of the punch section

5.1.1

Punch hole deviation correction

• This adjustment must be made in the following case:
The punch holes are on a slanted line.
3. In case the figure exceeds the above mentioned standard value, follow the procedures
shown below.
[1]
8
1. Set the mode to Punch mode for
2. Hold the output paper half and check
A10EF2C503DA
4. Open the upper cover [1].
[1]
A10EF2C502DA
• Loosen two screws [1].
A10EF2C500DA
Field Service Ver. 1.0 Jul. 2009
printing.
the displacement of the punch hole.
±
Standard value: 0 2.0 mm