Power Requirements - Ricoh B064 Service Manual

Hide thumbs Also See for B064:

Table of Contents

INSTALLATION REQUIREMENTS

1.1.5 POWER REQUIREMENTS

1. Make sure that the wall outlet is near the main machine and easily

accessible. Make sure the plug is firmly inserted in the outlet.

2. Avoid multi-wiring.

3. Be sure to ground the machine.

4. Never set anything on the power cord.

Input voltage level

Permissible voltage fluctuation

Standard 20 Amp

120 Volt Receptacle

Never turn off the main power switch when the operation power LED is lit

or flashing. To avoid damaging the hard disk or memory, press the

operation power switch to switch the power off, wait for the operation

power LED to go off, and then switch the main power switch off.

The Operation Power Switch LED (

• While the main machine is communicating with the network server

• While the machine is accessing the hard disk or memory when reading or

writing data.

There are two power switches on the machine:

• Main Power Switch.

Located on the front left corner of the machine and covered by a plastic cover.

This switch should always remain on unless the machine is being serviced.

• Operation Power Switch.

Located on the right side of the operation panel. This is the switch normally used

by the customer to power the machine on and off.

North America 120 V, 60 Hz: More than 20 A

Europe/Asia 220 V ~ 240 V, 50 Hz/60 Hz: more than 10 A

Standard 20 Amp

120 Volt Plug

) lights or flashes at the following times:

Table of Contents