Re-Installation - Ricoh D129 Service Manual

5. Bracket [D] ( x 1)
6. Pull the drum [E] towards the front
charge roller [F] using the release levers

Never touch the drum surface with bare hands.

Re-installation

1. Replace the drum and close the PCDU (
2. Put the opening cap [A in the previous procedure] back in its original place.
3. After replacing the drum, do these SPs:

SP 2001: Charge Bias Setting – make sure that this is at the default setting

SP 3001-2: P Sensor Initial Setting (P sensor = ID Sensor)

SP 2805: Process Setting

SP 2810-1: Grayscale Setting
SM
(the left side in the illustration) while releasing the
[G], and then remove the drum
x 2).
4-39
PCDU
.
D129/D130