Commands - D-Link xstack DGS-3612G Instruction Manual

The xStack DGS-3612G implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing criteria
for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command
enable 802.1x
disable 802.1x
show 802.1x auth_state
show 802.1x auth_configuration
config 802.1x capability ports
config 802.1x auth_parameter ports
config 802.1x init
config 802.1x auth_mode
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
show acct_client
show auth_client
show auth_diagnostics
show auth_session statistics
show auth_statistics
create 802.1x user
show 802.1x user
delete 802.1x user
create 802.1x guest_vlan
config 802.1x guest_vlan ports
show 802.1x guest_vlan
delete 802.1x guest_vlan
Each command is listed, in detail, in the following sections.
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{ports [<portlist> | all]}
{ports [<portlist> | all]}
[<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-65535> |
supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> | max_req
<value 1-10> | reauth_period <sec 1-65535> | enable_reauth [enable |
disable]}]
[port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd 32> [auth_port
<udp_port_number 1-65535> acct_port <udp_port_number 1-65535>]}
{ports [<portlist> | all]}
{ports [<portlist> | all]}
{ports [<portlist> | all]}
<username 15>
<vlan_name 32>
[<portlist> | all] state [enable | disable]
160
24
802.1X C
OMMANDS