D-Link xstack DGS-3612G Instruction Manual page 301

DGS-3612G:4# config ssh server maxsession 2 contimeout 300 authfail 2
Command: config ssh server maxsession 2 contimeout 300 authfail 2
Success.
DGS-3612G:4#
show ssh server
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the SSH server:
config ssh user
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to display the SSH server setting.
show ssh server
This command allows users to display the current SSH server setting.
None.
None.
DGS-3612G:4# show ssh server
Command: show ssh server
SSH Server Status
SSH Max Session
Connection timeout
Authenticate failed attempts
Rekey timeout
port
DGS-3612G:4#
Used to configure the SSH user.
config ssh user <username> authmode [hostbased [hostname
<domain_name> | hostname_IP <domain_name> <ipaddr>] |
password | publickey]
This command allows configuration of the SSH user authentication
method.
<username> - Enter a username of no more than 15 characters to
identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
wishing to log on to the Switch. The administrator may choose
between:
•
hostbased – This parameter should be chosen if the user
wishes to use a remote SSH server for authentication
purposes. Choosing this parameter requires the user to
input the following information to identify the SSH user.
•
hostname <domain_name> - Enter an alphanumeric string
of up to 32 characters identifying the remote SSH user.
•
hostname_IP <domain_name> <ipaddr> - Enter the
hostname and the corresponding IP address of the SSH
user.
password – This parameter should be chosen if the user wishes to
: Disabled
: 8
: 300
: 2
: never
: 22
298