D-Link xstack DGS-3612G Instruction Manual page 75

Command
show stp
show stp ports
show stp instance_id
show stp mst_config id
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable STP, globally, on the Switch:
disable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable STP on the Switch:
config stp version
Purpose
Syntax
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{<portlist>}
{<value 0-15>}
Used to globally enable STP on the Switch.
enable stp
This command allows the Spanning Tree Protocol to be globally enabled
on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable stp
Command: enable stp
Success.
DGS-3612G:4#
Used to globally disable STP on the Switch.
disable stp
This command allows the Spanning Tree Protocol to be globally disabled
on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#disable stp
Command: disable stp
Success.
DGS-3612G:4#
Used to globally set the version of STP on the Switch.
config stp version [mstp | rstp | stp]
72