D-Link xstack DGS-3612G Instruction Manual page 164

enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1x switch wide:
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
show 802.1x auth_configuration
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Network Access control
server application on the Switch. To select between port-based or MAC-
based, use the config 802.1x auth_mode command.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable 802.1x
Command: enable 802.1x
Success.
DGS-3612G:4#
Used to disable the 802.1x server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1x Network
Access control server application on the Switch. To select between port-
based or MAC-based, use the config 802.1x auth_mode command.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#disable 802.1x
Command: disable 802.1x
Success.
DGS-3612G:4#
Used to display the current configuration of the 802.1x server on the Switch.
show 802.1x auth_configuration {ports [<portlist> | all]}
The show 802.1x auth_configuration command is used to display the 802.1x
Port-based or MAC-based Network Access control local users currently
configured on the Switch.
ports <portlist> − Specifies a port or range of ports to view.
all – Specify to view all ports.
The following details are displayed:
802.1x Enabled / Disabled − Shows the current status of 802.1x functions on the
Switch.
Authentication Mode – Shows the authentication mode, whether it be by MAC
161