D-Link xstack DGS-3612G Instruction Manual page 128

config address_binding ip_mac ports
Restrictions
Example usage:
To configure address binding on the Switch:
DGS-3612G:4#config address_binding ip_mac ports 2 state enable
Command: config address_binding ip_mac ports 2 state enable
Success.
DGS-3612G:4#
show address_binding
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show IP-MAC Binding on the switch:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
all – specifies all ports on the switch.
state [enable | disable] – Enables or disables the specified range of ports.
Only administrator-level users can issue this command.
Used to display IP-MAC Binding entries.
[ip_mac {[all | ipaddress <ipaddr> mac_address <macaddr>]} |
blocked {[all | vlan_name <vlan_name> mac_address <macaddr>]}
| ports]
This command will display IP-MAC Binding entries. Three different
kinds of information can be viewed.
•
ip_mac – Address Binding entries can be viewed by entering
the physical and IP addresses of the device.
•
blocked – Blocked address binding entries (bindings between
VLAN names and MAC addresses) can be viewed by entering
the VLAN name and the physical address of the device.
•
ports - The number of enabled ports on a device.
all – For IP_MAC binding all specifies all the IP-MAC binding entries;
for Blocked Address Binding entries all specifies all the blocked VLANs
and their bound physical addresses.
<ipaddr> The IP address of the device where the IP-MAC binding is
made.
<macaddr> The MAC address of the device where the IP-MAC binding
is made.
<vlan_name> The VLAN name of the VLAN that is bound to a MAC
address in order to block a specific device on a known VLAN.
None
125