D-Link xstack DGS-3612G Instruction Manual page 302

config ssh user
Restrictions
Example usage:
To configure the SSH user:
show ssh user authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
use an administrator defined password for authentication. Upon
entry of this command, the Switch will prompt the user for a
password, and then to retype the password for confirmation.
publickey – This parameter should be chosen to use the publickey
on a SSH server for authentication.
Only administrator-level users can issue this command.
DGS-3612G:4# config ssh user Trinity authmode Password
Command: config ssh user Trinity authmode Password
Enter a case sensitive new password: *******
Enter the new password again for conformation:*******
Success.
DGS-3612G:4#
Used to display the SSH user setting.
show ssh user authmode
This command allows you to display the current SSH user setting.
None.
None.
DGS-3612G:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
UserName AuthMode
-------------------------- -------------------
Trinity Hostbased
DGS-3612G:4#
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
Hostname
-----------------
Triton
299
HostIP
-------------
11.1.1.1