D-Link xstack DGS-3612G Instruction Manual page 282

xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config authen_login
administrator level, the user must implement the enable admin command,
followed by a previously configured password. (See the enable admin
part of this section for more detailed information, concerning the enable
admin command.)
Parameters default – The default method list for access authentication, as defined by
the user. The user may choose one or a combination of up to four(4) of
the following authentication methods:
method_list_name – Enter a previously implemented method list name
defined by the user. The user may add one, or a combination of up to
four (4) of the following authentication methods to this method list:
Restrictions Only administrator-level users can issue this command.
tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the remote
RADIUS server hosts of the RADIUS server group list.
server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
none – Adding this parameter will require no authentication to
access the Switch.
tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server.
server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
none – Adding this parameter will require no authentication to
access the Switch.
Entering none or local as an authentication
NOTE:
protocol will override any other authentication that
follows it on a method list or on the default method list.
279