D-Link xstack DGS-3612G Instruction Manual page 50

download
Restrictions
Example usage:
To download a configuration file:
DGS-3612G:4#download config_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download config_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DGS-3612G:4#
DGS-3612G:4##-------------------------------------------------------------------
DGS-3612G:4##
DGS-3612G:4##
DGS-3612G:4##
DGS-3612G:4##
DGS-3612G:4##-------------------------------------------------------------------
DGS-3612G:4#
DGS-3612G:4#
DGS-3612G:4## BASIC
DGS-3612G:4#
DGS-3612G:4#config serial_port baud_rate 115200 auto_logout 10_minutes
Command: config serial_port baud_rate 115200 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DGS-3612G" appears followed by the
command prompt.
DGS-3612G:4#disable authen_policy
Command: disable authen_policy
Success.
DGS-3612G:4#
DGS-3612G:4##-------------------------------------------------------------------
DGS-3612G:4##
DGS-3612G:4##-------------------------------------------------------------------
DGS-3612G:4#
To download a firmware file to the FLASH memory of the Switch:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
exceed 64 alphanumeric characters.
config_fromTFTP − Download and install a configuration file on the Switch from
a TFTP server.
• <ipaddr> − The IP address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the switch
configuration file on the TFTP server. For example, C:\3226S.had.
•
{<path_filename 64>} – The second path_filename in the command
refers to the FLASH memory located on the switch. This drive is
nominated c: and those who wish to save the firmware, instead of
uploading it directly to the NV-RAM must specify the path on the
FLASH memory to place this file (ex. c:/config1). The filename cannot
exceed 64 alphanumeric characters.
The TFTP server must be on the same IP subnet as the Switch. Only
administrator-level users can issue this command.
DGS-3612G Configuration
Firmware: Build 1.00-B62
Copyright(C) 2000-2007 D-Link Corporation. All rights reserved.
End of configuration file for DGS-3612G
47