D-Link xstack DGS-3612G Instruction Manual page 43

create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the trusted host:
show trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the list of trust hosts:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host. The
Switch allows specification of up to four IP addresses that are allowed
to manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch,
provided the user knows the Username and Password.
<ipaddr> − The IP address of the trusted host to be created.
Only administrator-level users can issue this command.
DGS-3612G:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3612G:4#
Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
show trusted_host <ipaddr>
This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
<ipaddr> − The IP address of the trusted host.
None.
DGS-3612G:4#show trusted_host
Command: show trusted_host
Management Stations
IP Address
-----------------------
10.53.13.94
Total Entries: 1
DGS-3612G:4#
40