D-Link xstack DGS-3612G Instruction Manual page 131

enable address_binding trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable sending of IP-MAC Binding trap log messages on the Switch:
disable address_binding trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable sending of IP-MAC Binding trap log messages on the Switch:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#disable address_binding acl_mode
Command: disable address_binding acl_mode
Success.
DGS-3612G:4#
Used to enable the trap log for the IP-MAC binding function.
enable address_binding trap_log
This command, along with the disable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to the
SNMP agent and the Switch log when an ARP packet is received that
doesn't match the IP-MAC binding configuration set on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable address_binding trap_log
Command: enable address_binding trap_log
Success.
DGS-3612G:4#
Used to disable the trap log for the IP-MAC binding function.
disable address_binding trap_log
This command, along with the enable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn't match the IP-MAC binding configuration set on the
Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#disable address_binding trap_log
Command: disable address_binding trap_log
Success.
DGS-3612G:4#
128