D-Link xstack DGS-3612G Instruction Manual page 126

DGS-3612G:4#create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DGS-3612G:4#
To create address binding on the Switch for ACL mode:
DGS-3612G:4#create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04 mode acl
Command: create address_binding ip_mac ipaddress 10.1.1.3 mac_address
00-00-00-00-00-04 mode acl
Success.
DGS-3612G:4#
Once the ACL mode has been created and enabled (without previously created access profiles), the access profile table will look like
this:
DGS-3612G:4#show access_profile
Command: show access_profile
Access Profile Table
Access Profile ID : 13
=============================================================
Owner
Mask Option
Ethernet type
---------------------
Access ID : 1
Ports: 2
---------------------
0x800
=============================================================
Access Profile ID: 14
=============================================================
Owner
MASK Option
Source MAC
FF-FF-FF-FF-FF-FF
--------------------------
Access ID : 1
Ports: 2
--------------------------
00-00-00-00-00-04
=============================================================
Total Rule Entries: 2
DGS-3612G:4#
The show access_profile command will display the two access profiles created and their corresponding rules for every port on the
Switch.
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
: Address_binding
:
: Address_binding
:
Mode: Deny
Source IP MASK Protocol ID Mask
255.255.255.255 (0x0)
----------------------- --------------------------
Mode: Permit RX Rate(64Kbps): no_limit
----------------------- --------------------------
10.1.1.1
123
TYPE: Ethernet
RX Rate(64Kbps):
TYPE: IP