D-Link xstack DGS-3612G Instruction Manual page 53

show configuration
Parameters
Restrictions
Example usage:
To view the current configuration settings:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
1. Basic (serial port, Telnet and web
management status)
2. Storm control
3. IP group management (Single
IP)
4. Syslog
5. QoS
6. Port mirroring
7. Traffic segmentation
8. Port
9. Port lock
10. Time Range
11. ACL
12. IP-MAC address binding
13. VLAN
14. 802.1x
15. FDB
16. MAC address table notification
17. STP
18. Safeguard Engine
19. Banner and Prompt
20. SSH
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
startup_config - Entering this parameter will display configurations that are to be
used upon the next reboot of the Switch.
<path_filename 64> - The user may enter the path and file name of a configuration
file located on the FLASH memory of the Switch, which will then be displayed
None.
21. SNTP
22. LACP
23. IP
24. IGMP snooping
25. MLD Snooping
26. Access Authentication Control
27. AAA
28. ARP
29. Static Route
30. Policy Route
31. IGMP
32. PIM
33. DVMRP
34. RIP
35. MD5
36. OSPF
37. DNSR
38. DHCP Relay
39. VRRP
50