D-Link xstack DGS-3612G Instruction Manual page 159

DGS-3612G:4#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Enabled
DHCP Relay Agent Information Option 82 Policy : Replace
Interface
------------
System
DGS-3612G:4#
Example usage:
To show a single IP destination of the DHCP relay configuration:
DGS-3612G:4#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
Interface
------------
System
DGS-3612G:4#
enable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DHCP relay:
disable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Server 1
---------------
10.58.44.6
Server 1
---------------
10.58.44.6
Used to enable the DHCP/BOOTP relay function on the Switch.
enable dhcp_relay
This command is used to enable the DHCP/BOOTP relay function on
the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable dhcp_relay
Command: enable dhcp_relay
Success.
DGS-3612G:4#
Used to disable the DHCP/BOOTP relay function on the Switch.
disable dhcp_relay
This command is used to disable the DHCP/BOOTP relay function on
the Switch.
None.
Only administrator-level users can issue this command.
Server 2 Server 3
--------------- ---------------
Server 2 Server 3
--------------- ---------------
156
: Enabled
: 2
: 23
Server 4
--------------
Server 4
--------------