Vlan Commands - D-Link xstack DGS-3612G Instruction Manual

The xStack DGS-3612G incorporates protocol-based VLANs. This standard, defined by the IEEE 802.1v standard maps packets to
protocol-defined VLANs by examining the type octet within the packet header to discover the type of protocol associated with it.
After assessing the protocol, the Switch will forward the packets to all ports within the protocol-assigned VLAN. This feature will
benefit the administrator by better balancing load sharing and enhancing traffic classification. The Switch supports fourteen (14) pre-
defined protocols for configuring protocol-based VLANs. The user may also choose a protocol that is not one of the fourteen defined
protocols by properly configuring the userDefined protocol VLAN. The supported protocols for the protocol VLAN function on this
Switch include IPX Ethernet 2, IPX 802.2, IPX 802.3, IP, DEC, DEC LAT, SNAP, NetBIOS, AppleTalk, XNS, SNA, IPv6, RARP
and VINES.
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
create vlan
delete vlan
config vlan
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
create 802.1x guest_vlan
config 802.1x guest_vlan ports
show 802.1x guest_vlan
delete 802.1x guest_vlan
Each command is listed, in detail, in the following sections.
create vlan
Purpose
Syntax
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<vlan_name 32> {tag <vlanid 2-4094> | advertisement | {type {1q_vlan
{advertisement} | [protocol-ip | protocol-ipx802dot3 | protocol-ipx802dot2 |
protocol-ipxSnap | protocol-ipxEthernet2 | protocol-appleTalk | protocol-
decLat | protocol-sna802dot2 | protocol-snaEthernet2 | protocol-netBios |
protocol-xns | protocol-vines | protocol-ipV6 | protocol-userDefined <hex0x0-
0xffff> encap [ethernet | llc | snap | all] | protocol-rarp]}}
<vlan_name 32>
<vlan_name 32> {[add [tagged | untagged | forbidden] <portlist> |
advertisement [enable | disable]}
<vlan_name 32> delete <portlist>
[<portlist> | all] {state [enable | disable] | ingress_checking [enable | disable] |
acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}
{<vlan_name 32>}
{<portlist>}
<vlan_name 32>
[<portlist> | all] state [enable | disable]
NOTE: A specific protocol VLAN and a user defined protocol VLAN with
the same encapsulation protocol cannot coexist and will result in a Fail!
Message. (For example, if a user creates an Ethernet2 protocol VLAN, the
user can not create a userDefined protocol VLAN with an Ethernet
encapsulation)
Used to create a VLAN on the Switch.
create vlan <vlan_name 32> {tag <vlanid 2-4094> | advertisement | {type
{1q_vlan {advertisement} | [protocol-ip | protocol-ipx802dot3 | protocol-
ipx802dot2 | protocol-ipxSnap | protocol-ipxEthernet2 | protocol-
appleTalk | protocol-decLat | protocol-sna802dot2 | protocol-
106
15
VLAN C
OMMANDS