D-Link xstack DGS-3612G Instruction Manual page 214

DGS-3612G:4#delete arpentry ipv6 2D30::AC21
Command: delete arpentry ipv6 2D30::AC21
Success.
DGS-3612G:4#
config arp_aging time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ARP aging time:
show arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ARP table:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the age-out timer for ARP table entries on the Switch.
config arp_aging time <value 0-65535>
This command sets the maximum amount of time, in minutes, that an
ARP entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table.
time <value 0-65535> − The ARP age-out time, in minutes. The value
may be set in the range of 0-65535 minutes with a default setting of 20
minutes.
Only administrator-level users can issue this command.
DGS-3612G:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3612G:4#
Used to display the ARP table.
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
This command is used to display the current contents of the Switch's ARP
table.
ipif <ipif_name 12> − The name of the IP interface the end node or station
for which the ARP table entry was made, resides on.
ipaddress <ipaddr> − The network address corresponding to the IP
interface name above.
static − Displays the static entries to the ARP table.
None.
211