D-Link xstack DGS-3612G Instruction Manual page 137

config igmp
Restrictions
Example usage:
To configure the IGMPv2 for all IP interfaces.
show igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display IGMP configurations:
DGS-3612G:4#show igmp
Command: show igmp
IGMP Interface Configurations
Interface IP Address/Netmask Ver- Query
------------
System 10.90.90.90/8
p1
Total Entries: 2
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
that the Switch will wait for reports from members.
robustness_variable <value 1-255> − This value states the permitted
packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> − The Max Response Time
inserted into Group-Specific Queries and Group-and-Source specific
queries sent in response to Leave Group messages, and is also the
amount of time between Group-Specific Query and Group-and-Source
specific query messages. The default is 1 second
state [enable | disable] − Enables or disables IGMP for the specified IP
interface.
Only administrator-level users can issue this command.
DGS-3612G:4#config igmp all version 2
Command: config igmp all version 2
Success.
DGS-3612G:4#
Used to display the IGMP configuration for the Switch of for a
specified IP interface.
show igmp {ipif <ipif_name 12>}
This command will display the IGMP configuration for the Switch if no
IP interface name is specified. If an IP interface name is specified, the
command will display the IGMP configuration for that IP interface.
<ipif_name 12> − The name of the IP interface for which the IGMP
configuration will be displayed.
None.
---------------
20.1.1.1/8
Maximum Robust- Last
sion Response ness
Time
---- ------ --------
1 125 10
1 125 10
134
State
Member
Value Query
Interval
------- ----- -------
2 1 Enabled
2 1 Enabled