D-Link xstack DGS-3612G Instruction Manual page 23

DGS-3612G:4#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
===============================================================================
<Function Key>
Ctrl+C Quit without save
Ctrl+W Save and quit
------------------------------------------------------------------------------------------------------------------------------------------
Success.
DGS-3612G:4#
show greeting_message
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the currently configured greeting message:
DGS-3612G:4#show greeting_message
Command: show greeting_message
=========================================================================
=========================================================================
Success.
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.B62
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
Used to view the currently configured greeting message configured on
the Switch.
show greeting_message
This command is used to view the currently configured greeting
message on the Switch.
None.
None.
DGS-3612G Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.B62
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
<Control Key>
left/right/
up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
20