D-Link xstack DGS-3612G Instruction Manual page 213

create arpentry ipv6
Restrictions
Example usage:
To create a static ARP entry for the IPv6 address 10.48.74.121.125 and MAC address 00:50:BA:00:07:36:
DGS-3612G:4#create arpentry ipv6 2D30::AC21 00-50-BA-00-07-36
Command: create arpentry ipv6 2D30::AC21 00-50-BA-00-07-36
Success.
DGS-3612G:4#
delete arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To delete an entry of IP address 10.48.74.121.125 from the ARP table:
DGS-3612G:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DGS-3612G:4#
delete arpentry ipv6
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete IPv6 address entry 10.48.74.121.125 from the ARP table:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Only administrator-level users can issue this command. The Switch
supports up to 255 static ARP entries.
Used to delete a static entry into the ARP table.
delete arpentry {[<ipaddr> | all]}
This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP
address of the entry or all. Specifying all clears the Switch's ARP
table.
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Only administrator-level users can issue this command.
Used to delete a IPv6 entry from the ARP table.
delete arpentry ipv6 [<ipaddr> | all]
This command is used to delete a static ARP entry, made using the
create ipv6 arpentry command above, by specifying either the IP
address of the entry or all. Specifying all clears the Switch's ARP
table.
<ipv6addr> − The IPv6 address of the end node or station.
all − Deletes all ARP entries.
Only administrator-level users can issue this command.
210