D-Link xstack DGS-3612G Instruction Manual page 208

config safeguard_engine
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the safeguard engine for the Switch:
DGS-3612G:4#config safeguard_engine state enable utilization rising 45
Command: config safeguard_engine state enable utilization rising 45
Success.
DGS-3612G:4#
show safeguard_engine
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the safeguard engine status:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
To config ARP storm control for system.
config safeguard_engine {state [enable | disable] | utilization {rising
<value 20-100> | falling <value 20-100>} | trap_log [enable | disable] |
mode [strict | fuzzy]}
Use this command to configure Safeguard Engine to minimize the effects of
an ARP storm.
state [enable | disable] – Select the running state of the Safeguard Engine
function as enable or disable.
utilization – Select this option to trigger the Safeguard Engine function to
enable based on the following determinates:
•
rising <value 20-100> - The user can set a percentage value of
the rising CPU utilization which will trigger the Safeguard Engine
function. Once the CPU utilization rises to this percentage, the
Safeguard Engine mechanism will initiate.
•
falling <value 20-100> - The user can set a percentage value of
the falling CPU utilization which will trigger the Safeguard Engine
function to cease. Once the CPU utilization falls to this
percentage, the Safeguard Engine mechanism will shut down.
trap_log [enable | disable] – Choose whether to enable or disable the
sending of messages to the device's SNMP agent and switch log once the
Safeguard Engine has been activated by a high CPU utilization rate.
mode - Used to select the type of Safeguard Engine to be activated by the
Switch when the CPU utilization reaches a high rate. The user may select:
•
strict – If selected, this function will stop accepting all ARP
packets not intended for the Switch, and will stop receiving all
unnecessary broadcast IP packets, until the storm has subsided.
•
fuzzy - If selected, this function will instruct the Switch to minimize
the IP and ARP traffic flow to the CPU by dynamically allotting an
even bandwidth to all traffic flows.
Only administrator-level users can issue this command.
Used to display current Safeguard Engine settings.
show safeguard_engine
This will list the current status and type of the Safeguard Engine settings
currently configured.
None.
Only administrator-level users can issue this command.
205