D-Link xstack DGS-3612G Instruction Manual page 226

delete iproute default
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the default IP route:
show iproute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the contents of the IP routing table:
create iproute ipv6
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to delete a default IP route entry from the Switch's IP routing table.
delete iproute default
This command will delete an existing default entry from the Switch's IP
routing table.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#delete iproute default
Command: delete iproute default
Success.
DGS-3612G:4#
Used to display the Switch's current IP routing table.
show iproute {<network_address>}
This command will display the Switch's current IP routing table.
<network_address> − IP address and netmask of the IP interface that
is the destination of the route. The address and mask information can
be specified using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
None.
DGS-3612G:4#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway
------------------ -------------- ------------
10.0.0.0/8 0.0.0.0
Total Entries : 1
DGS-3612G:4#
Used to create IPv6 route entries to the Switch's IP routing table.
create iproute ipv6 <ipv6networkaddr> <ipv6addr> {<metric 1-65535>}
This command is used to create a primary and backup IP route entry to the
Switch's IP routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is the
destination of the route. Specify the address and mask information using the
Interface Hops Protocol
------- --------
System 1 Local
223