D-Link xstack DGS-3612G Instruction Manual page 16

show serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the serial port setting:
DGS-3612G:4#show serial_port
Command: show serial_port
DGS-3612G:4#
config serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure baud rate:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to display the current serial port settings.
show serial_port
This command displays the current serial port settings.
None.
None
Baud Rate : 115200
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
This command is used to configure the serial port's baud rate and auto
logout settings.
baud_rate [9600 | 19200 | 38400 | 115200]− The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, 115200.
auto_logout – Use this parameter to set the time the Switch will
automatically logout of the console connection, using the following
choices:
• never − No time limit on the length of time the console can be
open with no user input.
• 2_minutes − The console will log out the current user if there is
no user input for 2 minutes.
• 5_minutes − The console will log out the current user if there is
no user input for 5 minutes.
• 10_minutes − The console will log out the current user if there is
no user input for 10 minutes.
• 15_minutes − The console will log out the current user if there is
no user input for 15 minutes.
Only administrator-level users can issue this command.
13