Igmp Snooping Commands - D-Link xstack DGS-3612G Instruction Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
config router_ports_forbidden
enable igmp_snooping
show igmp_snooping
disable igmp_snooping
show igmp_snooping group
show router_ports
show igmp_snooping forwarding
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[vlan <vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-16711450>
| state [enable | disable] | fast_leave [enable | disable]}
[vlan <vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]}
<vlan_name 32> [add | delete] <portlist>
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} {[static | dynamic| forbidden]}
{vlan <vlan_name 32>}
Used to configure IGMP snooping on the Switch.
config igmp_snooping [vlan <vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 1-16711450> |
state [enable | disable]} | fast_leave [enable | disable]}
This command allows users to configure IGMP snooping on the Switch.
vlan <vlan_name 32> − The name of the VLAN for which IGMP snooping is to be
configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a host
can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a route
can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
leave_timer <sec 1-16711450> − Specifies the amount of time a Multicast address
will stay in the database before it is deleted, after it has sent out a leave group
message. The default is 2 seconds.
state [enable | disable] − Allows you to enable or disable IGMP snooping for the
specified VLAN.
fast_leave [enable | disable] – This parameter allows the user to enable the fast
leave function. Enabled, this function will allow members of a multicast group to
leave the group immediately (without the implementation of the Last Member Query
Timer) when an IGMP Leave Report Packet is received by the Switch.
Only administrator-level users can issue this command.
IGMP S
136
20
C
NOOPING OMMANDS