D-Link xstack DGS-3612G Instruction Manual page 255

Each command is listed, in detail, in the following sections.
config ospf router_id
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To configure the OSPF router ID:
enable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To enable OSPF on the Switch:
disable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To disable OSPF on the Switch:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the OSPF router ID.
config ospf router_id <ipaddr>
This command is used to configure the OSPF router ID.
<ipaddr> − The IP address of the OSPF router.
Only administrator-level users can issue this command.
DGS-3612G:4#config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3612G:4#
Used to enable OSPF on the Switch.
enable ospf
This command, in combination with the disable ospf command below,
is used to enable and disable OSPF on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable ospf
Command: enable ospf
Success.
DGS-3612G:4#
Used to disable OSPF on the Switch.
disable ospf
This command, in combination with the enable ospf command above,
is used to enable and disable OSPF on the Switch.
None.
Only administrator-level users can issue this command.
252