Jumbo Frame Commands - D-Link xstack DGS-3612G Instruction Manual

Certain switches can support jumbo frames (frames larger than the Ethernet frame size of 1536 bytes). To transmit frames of up to
9216 bytes (and 9220 bytes tagged), the user can increase the maximum transmission unit (MTU) size from the default of 1536 by
enabling the Jumbo Frame command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the jumbo frame function on the Switch:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command will allow Ethernet frames larger than 1536 bytes to be
processed by the Switch. The maximum size of the jumbo frame may
not exceed 9220 bytes tagged.
None.
None.
DGS-3612G:4#enable jumbo_frame
Command: enable jumbo_frame
Success.
DGS-3612G:4#
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command will disable the jumbo frame function on the Switch.
None.
None.
J
UMBO
307
47
F C
RAME OMMANDS