D-Link xstack DGS-3612G Instruction Manual page 256

show ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To show OSPF state:
DGS-3612G:4#show ospf
Command: show ospf
OSPF Router ID
State
OSPF Interface Settings
Interface IP Address
------------
System
ip2
ip3
Total Entries : 3
OSPF Area Settings
Area ID
--------------- ------
0.0.0.0
10.0.0.0
244.0.0.6
Total Entries : 3
Virtual Interface Configuration
Transit
Area ID
-----------
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#disable ospf
Command: disable ospf
Success.
DGS-3612G:4#
Used to display the current OSPF state on the Switch.
show ospf
This command will display the current state of OSPF on the Switch,
divided into the following categories:
General OSPF settings
OSPF Interface settings
OSPF Area settings
OSPF Virtual Interface settings
OSPF Area Aggregation settings
OSPF Host Route settings
None.
None.
: 10.1.1.2
: Enabled
Area ID
------------------ ---------
10.90.90.90/8 0.0.0.0
20.1.1.1/8 0.0.0.0
30.1.1.1/8 0.0.0.0
Type Stub Import Summary LSA Stub Default Cost Translate
-------------------------------------
Normal None
Normal None
NSSA Enabled
Virtual Hello
Neighbor Router Interval Interval
---------------
State Link
Status
-------- ---------
Disabled Link DOWN
Disabled Link DOWN
Disabled Link DOWN
-------------------------- ---------------
None
None
2
Dead Authentication Link
-------- -------- --------------
253
Metric
---------
1
1
1
None
Enabled
Status
------