D-Link xstack DGS-3612G Instruction Manual page 275

config mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch's MAC address table notification global settings:
config mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable port 7 for MAC address table notification:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#disable mac_notification
Command: disable mac_notification
Success.
DGS-3612G:4#
Used to configure MAC address notification.
config mac_notification {interval <int 1-2147483647> | historysize
<int 1-500>}
MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
interval <sec 1-2147483647> - The time in seconds between
notifications. The user may choose an interval between 1 and
2,147,483,647 seconds.
historysize <1-500> - The maximum number of entries listed in the
history log used for notification.
Only administrator-level users can issue this command.
DGS-3612G:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3612G:4#
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist> | all] [enable | disable]
MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
<portlist> - Specify a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC
address table notification on the Switch.
Only administrator-level users can issue this command.
DGS-3612G:4#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DGS-3612G:4#
272