Basic Switch Commands - D-Link xstack DGS-3612G Instruction Manual

The basic switch commands in the Command Line Interface (CLI) are listed (with the appropriate parameters) in the following table.
Command
create account
config account
show account
delete account
show session
show switch
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
save
reboot
reset
login
logout
show device status
config greeting_message
show greeting_message
Each command is listed, in detail, in the following sections.
create account
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[admin | user] <username 15>
<username>
<username>
{baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
{[config | system]}
{default}
Used to create user accounts.
create [admin | user] <username 15>
The create account command is used to create user accounts that
consist of a username of 1 to 15 characters and a password of 0 to 15
characters. Up to 8 user accounts can be created.
admin <username 15> - Enter a name between 1 and 15 alphanumeric
characters to define the administrator account created here.
user <username 15>- Enter a name between 1 and 15 alphanumeric
characters to define the user account created here.
Only Administrator-level users can issue this command.
B
ASIC
9
4
S C
WITCH OMMANDS