D-Link xstack DGS-3612G Instruction Manual page 243

DGS-3612G:4#config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Command: config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Success
DGS-3612G:4#
enable dvmrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DVMRP:
disable dvmrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable DVMRP:
show dvmrp routing_table
Purpose
Syntax
Description
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to enable DVMRP.
enable dvmrp
This command, in combination with the disable dvmrp command below,
is used to enable and disable DVMRP on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#enable dvmrp
Command: enable dvmrp
Success.
DGS-3612G:4#
Used to disable DVMRP.
disable dvmrp
This command is used, in combination with the enable dvmrp command
above, is used to enable and disable DVMRP on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3612G:4#disable dvmrp
Command: disable dvmrp
Success.
DGS-3612G:4#
Used to display the current DVMRP routing table.
show dvmrp routing table [ipaddress <network_address>]
The command is used to display the current DVMRP routing table.
240