config dst
Restrictions
Example usage:
To configure daylight savings time on the Switch:
show time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the time currently set on the Switch's System clock:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
e_mth - Configure the month in which DST ends.
•
<end_mth 1-12> - The month to end DST expressed as a
number.
s_time – Configure the time of day to begin DST.
•
<start_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
e_time - Configure the time of day to end DST.
•
<end_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
s_date - Configure the specific date (day of the month) to begin DST.
•
<start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to begin DST.
•
<end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Only administrator-level users can issue this command.
DGS-3612G:4#config dst repeating s_week 2 s_day tue s_mth 4
s_time 15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time
15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Success.
DGS-3612G:4#
Used to display the current time settings and status.
show time
This will display system time and date configuration as well as
display current system time.
None.
None.
199