D-Link xstack DGS-3612G Instruction Manual page 270

show ospf virtual_link
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display the current OSPF virtual interface configuration:
DGS-3612G:4#show ospf virtual_link
Command: show ospf virtual_link
Virtual Interface Configuration
Transit
Area ID
--------------- ----------------------
10.0.0.0
Total Entries: 1
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#delete ospf virtual_link 10.1.12 20.1.1.1
Command: delete ospf virtual_link 10.1.12 20.1.1.1
Success.
DGS-3612G:4#
Used to display the current OSPF virtual interface configuration.
show ospf virtual_link {<area_id> <neighbor_id>}
This command will display the current OSPF virtual interface configuration.
<area_id> − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the OSPF area in the OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area's Area Border Router. This is the router ID of the
neighbor router.
None.
Virtual
Neighbor Router Interval
20.0.0.0
Hello Dead Authentication Link
Interval
------------ ----------- -------------------- ------------
10 60 None
267
Status
DOWN