D-Link xstack DGS-3612G Instruction Manual page 263

config ospf aggregation
Restrictions
Usage example
To configure the OSPF area aggregation settings:
DGS-3612G:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Success.
DGS-3612G:4#
show ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display OSPF area aggregation settings:
DGS-3612G:4#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID
------------
10.1.1.1
244.0.0.6
Total Entries: 2
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type − The type of address aggregation. The user has two choices
for the LSDB type:
•
summary – Choosing this LSDB type will summarize routes that
are entering the OSPF area by redistribution.
•
•
nssa_ext – Choosing this LSDB type will summarize routes that
are entering the OSPF NSSA from an external source.
•
Only administrator-level users can issue this command.
Used to display the current OSPF area aggregation settings.
show ospf aggregation {<area_id>}
This command will display the current OSPF area aggregation settings.
<area_id> − Enter this parameter to view this table by a specific OSPF
area ID.
None.
Aggregated
Network Address Type
---------------------
10.0.0.0/8
11.0.0.0/8
advertise [enable | disable] − Allows for the advertisement
trigger to be enabled or disabled.
advertise [enable | disable]
trigger to be enabled or disabled.
LSDB Advertise
-------------- -------------
Summary Enabled
NSSA-Ext Enabled
260
−
Allows for the advertisement