D-Link xstack DGS-3612G Instruction Manual page 222

Example usage:
To set the authentication type for a VRRP entry:
DGS-3612G:4#config vrrp ipif Trinity authtype simple authdata tomato
Command: config vrrp ipif Trinity authtype simple authdata tomato
Success.
DGS-3612G:4#
show vrrp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To view the global VRRP settings currently implemented on the Switch (VRRP Enabled):
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
To view the VRRP settings set on the Switch.
show vrrp ipif <ipif_name 12> vrid <vrid 1-255>
This command is used to view current VRRP settings of the VRRP
Operations table.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to view the VRRP settings. This IP interface must
be assigned to a VLAN on the Switch.
vrid <vrid 1-255> - Enter the VRRP ID of a VRRP entry for which to
view these settings.
Only administrator-level users can issue this command.
DGS-3612G:4#show vrrp
Command: show vrrp
Global VRRP
Non-owner response PING : Disabled
Interface Name
Authentication type
VRID
Virtual IP Address
Virtual MAC Address
Virtual Router State
State
Priority
Master IP Address
Critical IP Address
Checking Critical IP
Advertisement Interval : 1 secs
Preempt Mode
Virtual Router Up Time : 2754089 centi-secs
Total Entries : 1
DGS-3612G:4#
:Enabled
: System
: No Authentication
: 2
: 10.53.13.3
: 00-00-5E-00-01-02
: Master
: Enabled
: 255
: 10.53.13.3
: 0.0.0.0
: Disabled
: True
219