D-Link xstack DGS-3612G Instruction Manual page 58

DGS-3612G:4#ping 10.48.74.121 times 4
Command: ping 10.48.74.121
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Ping statistics for 10.48.74.121
Packets: Sent =4, Received =4, Lost =0
DGS-3612G:4#
traceroute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To trace the routed path between the Switch and 10.48.74.121.
DGS-3612G:4#traceroute 10.48.74.121 probe 3
Command: traceroute 10.48.74.121 probe 3
1 <10ms 10.254.254.251
2 <10ms 10.55.25.35
3 <10ms 10.22.35.1
DGS-3612G:4#
enable autoconfig
Purpose
Syntax
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to trace the routed path between the Switch and a destination
endstation.
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> |
timeout <sec 1-65535> | probe <value <1-9>}
The traceroute command will trace a route between the Switch and a
give host on the network.
<ipaddr> - Specifies the IP address of the host.
ttl <value 1-60> - The time to live value of the trace route request. This is
the maximum number of routers the traceroute command will cross
while seeking the network path between two devices.
port <value 30000-64900> - The port number. Must be above 1024.The
value range is from 30000 to 64900.
timeout <sec 1-65535> - Defines the time-out period while waiting for a
response from the remote device. The user may choose an entry
between 1 and 65535 seconds.
probe <value 1-9> - The probe value is the number of times the Switch
will send probe packets to the next hop on the intended traceroute path.
The default is 1.
None.
Used to activate the autoconfiguration function for the Switch. This will
load a previously saved configuration file for current use.
enable autoconfig
55