D-Link xstack DGS-3612G Instruction Manual page 67

xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3612G:4#
create syslog host
Purpose Used to create a new syslog host.
Syntax
create syslog host <index 1-4> {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state
[enable | disable]}
Description The create syslog host command is used to create a new syslog host.
Parameters <index 1-4> − Specifies that the command will be applied to an index of
hosts. There are four available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where
syslog messages will be sent.
severity − Severity level indicator, as shown below:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
informational − Specifies that informational messages will be sent to the
remote host. This corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote
host. This corresponds to number 4 from the list above.
−
all
are generated by the Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have
been assigned Facility values. Processes and daemons that have not
been explicitly assigned a Facility may use any of the "local use" facilities
or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates the facility
values that the Switch currently supports.
Numerical
Code
0
1
2
3
4
5
6
7
8
9
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
Specifies that all of the currently supported syslog messages that
Facility
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by
line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
64
syslog