D-Link xstack DGS-3612G Instruction Manual page 120

delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1, master port 5 with group members ports 5-7 plus port 9:
DGS-3612G:4#config link_aggregation group_id 1 master_port 5 ports 5-7,9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Success.
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to delete a previously created link aggregation group.
delete link_aggregation group_id <value 1-32>
This command is used to delete a previously configured link aggregation
group.
<value 1-32> − Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies each of the
groups.
Only administrator-level users can issue this command.
DGS-3612G:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3612G:4#
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-32> {master_port <port> |
ports <portlist> | state [enable | disable]
This command allows users to configure a link aggregation group that was
created with the create link_aggregation command above. The DGS-3612G
supports link aggregation cross box which specifies that link aggregation
groups may be spread over multiple switches in the switching stack.
group _id <value 32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number identifies each of
the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of
the link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link
aggregation group.
state [enable | disable] − Allows users to enable or disable the specified link
aggregation group.
Only administrator-level users can issue this command. Link aggregation
groups may not overlap.
117