D-Link xstack DGS-3612G Instruction Manual page 150

DGS-3612G:4#config mld_snooping mrouter_ports default add 1-10
Command : config mld_snooping mrouter_ports default add 1-10
Success.
DGS-3612G:4#
config mld_snooping mrouter_ports_forbidden
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure MLD snooping forbidden multicast router ports:
DGS-3612G:4#config mld_snooping mrouter_ports_forbidden default add 1-3
Command : config mld_snooping mrouter_ports_forbidden default add 1-3
Success
DGS-3612G:4#
config mld_snooping querier
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure ports on the Switch as forbidden router ports.
config mld_snooping mrouter_ports_forbidden <vlan_name 32> [add |
delete] <portlist>
This command allows the user to designate a port or range of ports as being
forbidden from being connected to multicast enabled routers. This ensures that
these configured forbidden ports will not send out routing packets.
vlan <vlan_name 32> − The name of the VLAN on which the router port will be
forbidden.
add | delete – Specify to add or delete ports as forbidden router ports.
<portlist> - Specify a port or range of ports to be configured as forbidden router
ports.
Only administrator-level users can issue this command.
Used to configure the timers and settings for the MLD snooping querier for the Switch.
config mld_snooping querier [vlan <vlan_name 32> | all] {query_interval <sec 1-
65535> | max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_listener_query_interval <sec 1-25> | state [enable | disable]}
This command allows the user to configure the time between general query
transmissions, the maximum time to wait for reports from listeners and the permitted
packet loss guaranteed by MLD snooping.
vlan <vlan_name 32> − The name of the VLAN for which to configure the MLD querier.
all – Specifies all VLANs are to be configured for the MLD querier.
query_interval <sec 1-65535> - Specifies the amount of time between general query
transmissions. The user may specify a time between 1 and 65535 seconds with a
default setting of 125 seconds.
max_response_time <sec 1-25> - The maximum time to wait for reports from listeners.
The user may specify a time between 1 and 25 seconds with a default setting of 10
seconds.
robustness_variable <value 1-255> - Provides fine-tuning to allow for expected packet
loss on a subnet. The user may choose a value between 1 and 255 with a default
setting of 2. If a subnet is expected to be lossy, the user may wish to increase this
interval.
147