D-Link xstack DGS-3612G Instruction Manual page 110

xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
create vlan
snaEthernet2 | protocol-netBios | protocol-xns | protocol-vines |
protocol-ipV6 | protocol-userDefined <hex0x0-0xffff> encap [ethernet | llc
| snap | all] | protocol-rarp]}}
Description This command allows the creation of a VLAN on the Switch. The user may
choose between an 802.1Q VLAN or a protocol-based VLAN.
<vlan_name 32> − The name of the VLAN to be created.
Parameters
tag <vlanid 2-4094> − The VLAN ID of the VLAN to be created. Allowed values
= 2-4094
type – This parameter uses the type field of the packet header to determine
the packet protocol and destination VLAN. There are two main choices of
types for VLANs created on the Switch:
•
•
The following parameters allow for the creation of protocol-based VLANs. The
Switch supports 14 pre-configured protocol-based VLANs plus one user
defined protocol based VLAN where the administrator may configure the
settings for the appropriate protocol and forwarding of packets (15 total).
Selecting a specific protocol will indicate which protocol will be utilized in
determining the VLAN ownership of a tagged packet. Pre-set protocol-based
VLANs on the Switch include:
•
•
•
•
•
•
•
•
•
1q_vlan – Allows the creation of a normal 802.1Q VLAN on the
Switch.
advertisement − Specifies that the VLAN is able to join GVRP.
protocol-ip – Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent
with this protocol. This packet header information is based on the
Ethernet protocol.
protocol-ipx802dot3 - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by Novell NetWare 802.3 (IPX - Internet Packet Exchange).
protocol-ipx802dot2 - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by Novell NetWare 802.2 (IPX - Internet Packet Exchange).
protocol-ipxSnap - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by Novell and the Sub Network Access Protocol (SNAP).
protocol-ipxEthernet2 - Using this parameter will instruct the Switch
to forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by Novell Ethernet II Protocol.
protocol-appleTalk - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by the AppleTalk protocol.
protocol-decLAT - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by the Digital Equipment Corporation (DEC) Local Area
Transport (LAT) protocol.
protocol–sna802dot2 - Using this parameter will instruct the Switch
to forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by the Systems Network Architecture (SNA) 802.2 Protocol.
protocol–snaEthernet2 - Using this parameter will instruct the Switch
to forward packets to this VLAN if the tag in the packet header is
107