Advanced Configuration And Fxs/Fxo Ports Parameters; Table 9: Ht488 Advanceds; Ettings Age Efinitions - Grandstream Networks HT-488 User Manual

A C
DVANCED ONFIGURATION AND
To login to the Advanced Setting and FXS port configuration pages, administrator password is required.
The default administrator password is "admin". User can change the administrator password here. The
password is case sensitive and the maximum length is 25 characters.
T 9: HT488 A
ABLE DVANCED
Admin Password
Home NPA
Layer 3 QoS
Layer 2 QoS
No Key Entry timeout
STUN Server
Keep-alive interval
Use NAT IP
Firmware Upgrade and
Provisioning
Firmware Server Path
Config Server Path
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Automatic Upgrade
Firmware Key
Caller ID Scheme
Onhook Voltage
Polarity Reversal
NTP server
Syslog Server
Syslog Level
Grandstream Networks, Inc.
FXS/FXO
PORTS
S P D
ETTINGS AGE EFINITIONS
Administrator password. Only administrator can configure the "Advanced Settings"
page. Password field is purposely blanked for security reason after clicking update and
saved. The maximum password length is 25 characters.
Local area code for North American Dial Plan.
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 48.
Layer 2 QoS settings. Default setting is blank. Other VLAN supported equipments
required if configured these settings.
Default is 4 seconds. User can short or extend that depends on digits dialed
IP address or Domain name of the STUN server.
Default is 20 seconds. The interval of sending dummy UDP packet to keep NAT "pin
hole" open.
NAT IP address used in SIP/SDP message. Default is blank.
Default method is HTTP. Firmware upgrade may take up to 10 minutes depending on
network environment. Do not interrupt the firmware upgrading process.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
Default is blank. If configured, HT- 488 will request the firmware file with the prefix.
This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is "Yes".
For firmware encryption. It should be 32 digit in Hexadecimal Representation. End user
should keep it blank.
• Bellcore (North America)
• CID (Canada)
• DTMF (Brazil)
• DTMF (Sweden)
• DTMF (Denmark)
• ETSI-DTMF (Finland, Sweden)
• ETSI-FSK (France, Germany, Norway, Taiwan, UK-CCA)
Select the onhook voltage to suit different area or PBX.
Default is No. If set to Yes, polarity will be reversed upon call establishment
and termination.
URI or IP address of the NTP (Network Time Protocol) server, which the HT386 will
use to synchronize the date/time.
The IP address or URL of syslog server, especially useful for ITSP (Internet Telephone
Service Provider)
Select the ATA to report the log level. Default is NONE. The level is either one of
DEBUG, INFO, WARNING or ERROR. Syslog messages are sent based on the
following events:
•
product model/version on boot up (INFO level)
•
NAT related info (INFO level)
•
sent or received SIP message (DEBUG level)
•
SIP message summary (INFO level)
HT488 User Manual
Firmware 1.0.3.64
P
ARAMETERS
Page 21 of 33
Last Updated: 4/2007