Advanced Configuration And Fxs Ports Parameters; Table 9: Ht-386 Advanced - Grandstream Networks HT-386 User Manual

PSTN Access Code
A C
DVANCED ONFIGURATION AND
To login to the Advanced Setting and FXS port configuration pages, administrator password is required.
The default administrator password is "admin". User can change the administrator password here. The
password is case sensitive and the maximum length is 25 characters.
T 9: HT-386 A
ABLE DVANCED
Admin Password
Home NPA
Layer 3 QoS
Layer 2 QoS
No Key Entry timeout
STUN Server
Keep-alive interval
Use NAT IP
Firmware Upgrade and
Provisioning
Firmware Server Path
Config Server Path
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Automatic Upgrade
Firmware Key
Caller ID Scheme
Grandstream Networks, Inc.
US/Canada where daylight saving time is applicable:
04,01,7,02,00;10,-1,7,02,00;60
This means the daylight saving time starts from the first Sunday of April at
2AM and ends the last Sunday of October at 2AM. The saving is 60 minutes
(1hour).
Default is "*00", user can change it. By pressing the code user can switch the
phone to PSTN line connected to the Line port of ATA and make PSTN
outgoing calls. This is called PSTN Pass Through.
FXS
PORTS
S P D
ETTINGS AGE EFINITIONS
Administrator password. Only administrator can configure the "Advanced
Settings" page. Password field is purposely blanked for security reason after
clicking update and saved. The maximum password length is 25 characters.
Local area code for North American Dial Plan.
This field defines the layer 3 QoS parameter which can be the value used for
IP Precedence or Diff-Serv or MPLS. Default value is 48.
Layer 2 QoS settings. Default setting is blank. Other VLAN supported
equipments required if configured these settings.
Default is 4 seconds. User can short or extend that depends on digits dialed
IP address or Domain name of the STUN server.
Default is 20 seconds. The interval of sending dummy UDP packet to keep
NAT "pin hole" open.
NAT IP address used in SIP/SDP message. Default is blank.
Default method is HTTP. Firmware upgrade may take up to 10 minutes
depending on network environment. Do not interrupt the firmware upgrading
process.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
Default is blank. If configured, HT-386 will request the firmware file with the
prefix. This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is "Yes".
For firmware encryption. It should be 32 digit in Hexadecimal Representation.
End user should keep it blank.
• Bellcore (North America)
• CID (Canada)
• DTMF (Brazil)
• DTMF (Sweden)
• DTMF (Denmark)
HT-386 User Manual
Firmware 1.0.3.64
P
ARAMETERS
Page 21 of 34
Last Updated: 2/2007